While I waited to get parts back for the suspension rebuild, I started cleaning up the engine bay especially the firewall and lower frame rails. I reran the fuel line along with a pressure regulator. Due to the electric fuel pump already installed, I ran the fuel line on the back of the firewall. Also started to paint & assembly some parts onto the 496 Chevy big block. This round started about the end of October 2013. Take a look below.....
This is the reproduction battery relocate cover for AC cars and BB with AC that goes into that large hole in the above center picture
Engine bay finally complete after scarping, cleaning, sanding and painting, running new fuel lines and battery cable to driver's side of the bay.